1 Smooth and level surface. Cover and refrigerate until firm, about 4 hours.

2 A flat or level surface.

3 The set of points is called a level surface.

4 The results show that fine grains and level surface of the deposits can be got by increasing electrolyte flow velocity and scanning speed of nozzle at the same current density.

5 Place the trap on a level surface in the area where you usually feed them.

6 Figure 7 - 12 shows a body of mass m on a level surface.

7 And, at this point, I have the tangent plane to the level surface OK, so this is tangent plane to the level.

8 Asymmetric dual - angle milling cutter used to point chutes, and inclined spiral groove, level surface.