1) High slew rate, wide bandwidth, single supply operational amplifier.

2) There are also no slew rate limiting capacitors in the circuit.

3) The HA-5002 is a monolithic, wideband, high slew rate, high output current, buffer amplifier.

4) Single Supply, High Slew Rate, Input Offset Voltage Operational Amplifiers.

5) A programmable slew rate allows a controlled transition from one load setting to another to minimize induced voltage drops on inductive power wiring, or control induced transients on a test device.

6) The Intersil HA-2539 represents the ultimate in high slew rate, wideband,[http:///slew rate.html] monolithic operational amplifiers.

7) Slew rate is defined as the change in current over time.

8) Single Supply, High Slew Rate, Low Input Offset Voltage Operational Amplifiers.

9) Therefore, both minimum transition time and slew rate must be considered in the determination of actual transition time.

10) Current-feedback amplifiers have a higher slew rate than do voltage-feedback amplifiers.

11) If the transient from one setting to another is large, the actual transient time can be calculated by dividing the current transition by the slew rate.

12) While all modern op amps have push-pull OUTPUT stages of some sort, many are still asymmetrical, and have a greater slew rate in one direction than the other.