1. Midplane Flow analysis is most accurate for thin - wall part geometries.

2. It realized the transformation of solid model into midplane model in injection molding simulation by means of alternative algorithm of MAT and developed corresponding program module .

3. The two views are aligned along the midplane of the body and pointing in opposite directions.

4. The exact formula set for the midplane of the uniform-field wedge magnet is derived.

5. The generation of midplane model mesh is on the basis of finite element analysis of middle-face-flow technique for injection molding simulation.

6. The theory fully considered the effects of shell-stiffener interaction and influence of midplane shift.

7. The wakefield effects induced by the front particle, using impulse approximation, are equivalent to additional momentum increases of the tail particle at the midplane of achromatic system.

7.

8. Notice that the first component selected is the component offset from the joint midplane .

9. It is also shown that the residual stresses are compressive below the surface and tensile in the center, and the minimum of local residual tensile stress occurs at the midplane of the plate thickness.

10. We may use the plane stress analysis for determining deflections in the midplane of the beam.