1. The optimum curing conditions of fluororubber blends were determined by changing the temperature and the time.

2. Various kinds of mixes and products, based on fluororubber ( - 40℃ -- 200℃ ), silicone rubber ( - 70℃ -- 300℃ ) and fluoro - silicone rubber.

3. The optimum post curing conditions of fluororubber blends were determined by changing the temperature and the time.

4. According to the primary properties of fluororubber, the progress on the modifying research of fluororubber blends was introduced.

5. High-temperature models have a fluororubber seal and high-temperature grease, for extreme conditions where lower speeds are required.

6. Foreign Fluororubber more than 50 varieties, but only over 10 domestic species.

7. The pretreating superfine fluororubber powder can partly replace the fluororubber, thereby reducing the cost of fluororubber sizing.

8. Fluororubber is excellent on the heat-resistant properties, it is the kind of rubber which can be well used under a environment at a high temperature, and have a great value in application.

9. The results showed that hygroscopic water content of strontium nitrate could be decreased by coating with nitrated cellulose and fluororubber, and the ignition ratio of primer could be increased.

10. And that the Asahi Chemical Ind. Co. has developed the "Non-adhesion technology"too. There has been a big reduce in the adhesion of the fluororubber surface, and the rate of finished products has...

11. The results showed that the mechanical properties of post cured fluororubber were significantly improved.

11.

12. Co. has developed the "Non-adhesion technology"too. There has been a big reduce in the adhesion of the fluororubber surface, and the rate of finished products has bee improved in the mou...

13. The results showed that the compound could improve the scorch safety, the compression set and the tensile strength of fluororubber compound.

14. The preparation technique was also introduced. The results showed that the blend met the requirement of bar fluororubber seals.

15. Co. has developed the "Non-adhesion technology"too. There has been a big reduce in the adhesion of the fluororubber surface, and the rate of finished products has bee improved int...

16. It's adequate for kind of mechanical seal, it's material conrist of Fluororubber, Silastie, Buna n rubber and each latex ware.